Our Freestyle Sink

Our bespoke Odyssey Freestyle Sink takes handwashing to another level. Giving you the ability to fit our technology into your own setting.

Like all our Sinks our Freestyle offers hand hot water with an adjustable temperature range of 22- 48c within a few seconds. You have the option of an infrared tap or a motion sensor along with our standard push buttons. With a 270ml water dispense, you can have both hot and cold water within seconds. All our units only use power for the few seconds needed to heat the water to the required temperature and you can have either a 2kw or 3kw option with our 12volt battery powered option available in 2017. Along with the rest of our products the Odyssey Freestyle is available to purchase and hire, including free delivery and collection.

Product Options

Tap Options:

  • Standard* Swivel 22mm Radius 11mm
  • Low Profile – *Additional Option of a Motion Sensor for a Standard and Low Profile tap

Bowl Options:

  • Square Small 325mm x 353mm, Depth 150mm
  • Square Large 325mm x 353mm, Depth 200mm
  • Round Small Dim 295mm radius 147.6mm Deep 116mm
  • Round Medium Dim 330mm radius 165mm Deep 135mm
  • No Bowl
  • Choice of 2 bowls

Water Dispense:

  • Hot and Cold water option
  • Hot Water 270ml
  • Cold Water on demand

Press button / micro switch:

  • Mounted in box
  • On fly lead 30mm diameter 15mm radius

Water Containers:

  • 2 x 10 Litres* as standard  320mm High x 230mm Deep x 200mm Wide
  • 2 x  23 Litres * additional £15 per container 350mm High x 260mm x 350mm Wide
  • 2 x 25 Litres* additional £15 per container 540mm High x 200mm Deep x 360mm Wide
Dimensions
Style Freestanding
Height to top of bowl 700mm
Total height include tap 900mm
Width 320mm
Unit depth 320mm
Bowl depth 150mm
Infra-red taps? Available
Goose neck taps? Available
Water delivery on each button press 170ml or 270ml
Temperature range 22C to 48C (fully adjustable)
Instructions

Yes, you need to be a bit handy at DIY but we believe it isn’t too difficult to set up. Firstly, do not plug into the mains power unit you have finished. The Odyssey Freestyle Box large or standard size (depending on if you have had hot or hot & cold water options) needs to be positioned vertically inside your cupboard, bar, food samplings trolley etc. Use the fixing bracket provided and making sure the inlet connector where the clear fresh water pipe will be positioned is pointing down.

The fresh water container needs to be fitted directly below the clear fresh water pipe. The fresh water pipe must have not bends or kinks and should be cut to the required length. i.e. so it just sits at the bottom of the fresh water container.

  • Your counter / work top needs holes to be drilled for the
  • Bowl (dimensions depending on your bowl selection)
  • Tap (dimensions depending on your selection)
  • Depending on your option either
  • Motion Sensor
  • Micro switches / buttons

Pop your waste water container directly under your waste (green) pipe. Again making sure you have no bends and kinks and cutting any excess pipe so the waste pipe sits just inside the neck of the waste water container.
To fit your micro switch / button
Unscrew the silver and black connections, underneath the green button. Now place the black sleeve over the length of wire then attach the two spade connections together. They are male and female but there is no positive or negative and they can be put together either way. Now slide the black sleeve back over the two spade connections and using the 2 tie straps secure it in position to ensure it’s a water resistance connection.
Fill your fresh water container with water
Your Odyssey Freestyle Sink is now ready to USE !
Once switched on your Odyssey Freestyle will prime itself
You can now adjust your water temperature by turning the dial
Please make sure you keep your Odyssey Freestyle in a dry and frost free atmosphere


Options
  1. Standard Hot Only no bowl 2 x 10 litre water containers
    • Press button / micro switch mounted in box Or Press button / micro switch on fly lead
    • 30mm diameter 15mm radius
    • Hot Only
  2. Standard Hot Only 1 bowl 2x 10 litre water containers
    • Press button / micro switch mounted in box Or Press button / micro switch on fly lead
    • 30mm diameter 15mm radius
    • Bowl Options
    • Square Small 325mm x 353mm, Depth 150mm
    • Square Large 325mm x 353mm, Depth 200mm
    • Round Small Dim 295mm radius 147.6mm Deep 116mm
    • Round Medium Dim 330mm radius 165mm Deep 135mm
    • Hot Only
  3. Standard Hot Only 1 bowl 2 water containers motion sensor
    • Motion Sensor on fly lead
    • Bowl Options
    • Square Small 325mm x 353mm, Depth 150mm
    • Square Large 325mm x 353mm, Depth 200mm
    • Round Small Dim 295mm radius 147.6mm Deep 116mm
    • Round Medium Dim 330mm radius 165mm Deep 135mm
  4. Hot and Cold 1 bowl 2 water containers micro switches
    • Motion Sensor on fly lead
    • Press button / micro switch mounted in box Or Press button / micro switch on fly lead
    • 30mm diameter 15mm radius
    • Bowl Options
    • Square Small 325mm x 353mm, Depth 150mm
    • Square Large 325mm x 353mm, Depth 200mm
    • Round Small Dim 295mm radius 147.6mm Deep 116mm
    • Round Medium Dim 330mm radius 165mm Deep 135mm
    • Hot & Cold
    • Measured hot water, cold on demand

Additional Bowls

  • Medium / Large
  • Small

Additional Water Containers

  • 10 Litres
  • 20 Litres

Sign up to the newsletter and

Receive £5 off any purchase*

Offers, news and updates from Mobile Sink

*excludes hire